Lamp types
Structure using a white strobe
Structure using a Red/White Strobe
Closeup of
Structure using high intensity white lights and a medium intensity white strobe
The lights generally come in two forms:
Red lamps that are either constantly illuminated or turn on and off slowly in a cycle of a few seconds.
White xenon discharge flashers.
Both types were in use in the United Kingdom until recently, however new regulations stipulate the use of red lamps at nighttime only. Xenon flashers are therefore gradually being phased out.
In the United States and Canada, there are several types of lights:
Obstruction lights (that are constantly illuminated)
Red Beacons/Red strobes
High Intensity White (Strobe) Lights
Medium Intensity White (Strobe) Lights
Traditionally, red lamps (or beacons) use incandescent filament bulbs. In order to improve the otherwise quite short lifespan, they are made with a ruggedised design and are run below normal operating power (under-running). A recent development has been the use of arrays of high power red LEDs in place of incandescent bulbs, which has only been possible since the development of LEDs of sufficient brightness. LED based lamps have a significantly longer lifespan than incandescent bulbs, thus reducing maintenance costs and increasing reliability. Several manufacturers have also developed medium intensity white strobes based on LED technology to replace Xenon.
Xenon flashers, whilst more visually impressive, tend to require frequent replacement and so have become a less favoured option. However, with the advent of LEDs, white strobes are still somewhat desired.
It is common to find structures with white camiseta sevilla 2011 xenon flashers/white strobes during the daytime, and red lights at night. Red lights are commonly found to be used in urban areas, since it is easier for pilots to spot them from above. White strobes (that flash 24/7) may also be used in camiseta sevilla 2011 urban areas. However, it has been recommended that flashing white strobes should not be used in densely populated areas; the lights usually merge with background lighting at nighttime, making it difficult for pilots to spot them and thereby aggravating the hazard. In addition, residents near the lit structure will complain of light trespass.
In rural areas, red beacons/strobes may also be used during nighttime. However, white strobes are (sometimes) preferred since it reduces maintenance cost (i.e. no maintenance of painting, no red side lights) and there are no background lights that would blend with the strobes.
For white strobes, there is a medium intensity white strobe and a high intensity white strobe. Medium Intensity White Strobes are usually used on structures that are between 200500 feet (61-152.4 meters). If a medium white strobe is used on a structure greater than 500 feet (152.4 meters), the structure must be painted.
The common medium white strobe flashes 40 times in a minute, at an intensity of 20,000 candelas for daytime/twilight, and 2,000 candelas at nighttime.
没有评论:
发表评论